STHS Forum

slapshot wrote:Thanks.

What else determines attendance other than star power? Also what determines the amount of seats an arena has?

Attendence?
Your price ticket vs. league average. And a bit of randomness, I guess.
That's about it.


Amount of seats?
The league's responsible gets to set these settings.
If you are the president/owner of license/commish of the league, get into each team's page and you get to set it. Otherwise it's in your League settings as well if you want to set a specific number similar to each team.

How is this "variable overall" thing work? Lets say I set it to a maximum change of 3. Does that mean my player who is rated lets say 70 can have his rating go up or down on a game by game basis? What determines whether it goes up or down what determines how much it goes up or down by?

Why is there no way to undo a pick in the Entry Draft?

variable overall?

Theire no way to under a pick in the Entry Draft.

Ratings Change Active, not variable overall, my bad

So what if I've inputted hundreds of players already but I make a mistake? I can't undo the pick, I have to start all over again? Can you at least add that option in your next release?

Also about this:

"Forwards Play All Positions - check this option if you want to have farm forwards be able to play any of the forward positions without losing ability (if this is not checked a RW plugged in at LW will not perform as well as if he were at RW)"

How much ability does the player lose if they play the wrong position?

Sorry but I cannot do a undo command.

The % of lose ss a secret.

Why not?

Because it's like that the STHS is programmed and I won't change it, sorry.

Do you understand how annoying that is though?

slapshot wrote:Do you understand how annoying that is though?

Why would you want to undo a draft pick? Or better yet, how many times have you made a wrong pick that you actually need a command built in?? If you make a mistake just trade the player to the correct team when you're all done

I tried going through the entry draft 3 times before I gave up. You're searching for the player so sometimes the search ends up on the wrong player and I pull the trigger to quick. But then that player would be listed as the wrong draft choice.

I don't see why something so trivial is so hard to do...Instead of adding that "Open/Close Team View" thing which I'm sure noone uses, why not add this? Makes more sense to me.

Also, how do you add a player to a team? The only way I've seen is via CSV